Gigabit Ethernet Controller PMC - PMC401
A quad (4-port) 10/100/1000 Mbit Ethernet PMC based controller for use in embedded applications. The PMC401 contains four Intel 82574IT, low power single port Gigabit Ethernet controllers.
These controllers offer a lot of standard Ethernet related features, plus extra features like support for hardware-based time stamping, jumbo frames and host offloading features like IPv4 and IPv6 checksum.
The Ethernet controllers are transparently connected to the PMC PCI interface via a PLX PCI to PCIe bridge and PCIe switch. The PMC PCI interface is converted into a one lane 2.5Gbs PCIe for each controller.
The front panel has four RJ45 copper connectors with LEDs for a combined link/activity indication.
For each Ethernet controller is a bootflash chip available in which a bootloader may be programmed (bootloader not included).
The PMC401 is available in standard temperature, 0 to +60°C and industrial temperature, -40 to +85°C.
Driver support is included in most commonly used operating systems, contact us for further specific information regarding operating system and driver support.
Single slot PMC (IEEE 1386.1-2001) with front I/O (no rear I/O)>
PCI specification 3.0, 32bit, 33/66MHz, 3.3V or 5V signalling>
Four auto negotiating 10/100/1000 Ethernet ports, RJ45 copper connector with built-in magnetics>
IEEE802.3 Ethernet interface for 1000BASE-T, 100BASE-T and 10BASE-T applications>
Boot Flash for each Ethernet controller>
Host offloading features, like IPv4 and IPv6 checksum offload support>
9kB jumbo frames support>
Combined Activity/Link LED per port>
Software support available in commonly used operating systems>
Support for hardware-based time stamping of IEEE1588 and 802.1as packets enabling high precision time synchronization over Ethernet>
Combination of Conduction Cooled PMC and Standard PMC with front panel bezel